1, if your area may be more seasonal humidity, opened the condenser condenser try to find a free-style box, such as making a small shock box. Put some moisture-proof beads inside again, if the desiccant is wet, it indicates that the humidity is too high, open the microphone hood, and check whether there is damp phenomenon on the metal inner wall. If the microphone metal wall has damp phenomenon, with a hair dryer dry, and then access equipment for 10 minutes after the test.
2, rain and dust, rain is condenser microphone's natural enemies, condenser microphone diaphragm due to water will accelerate the corrosion of metal materials, and will make the internal circuit wire short circuit. Do not rush into the end of the box, the use of hair dryer for drying and then put into it.
Nowadays, most of the Condenser microphone on the market are powered by phantom power, that is, most are connected to the console via a microphone cable for power supply. So you should try to avoid the hot-swappable microphone operation, frequent large voltage fluctuations will greatly reduce the life of the microphone. So try to connect the microphone to the mixer before turning on a channel, then turn it on again. If your vacuum tube microphone can be connected directly to the power supply, then it is equally important to avoid hot plugging. Before you connect the microphone to the mixer, do not turn on the microphone's power switch.
BY-VM01 Condenser Mini Microphone
The BOYA BY-VM01 mini Microphone is designed for recording audio while making videos, along with this mic your camera can create higher-quality audio. It designed for use with a digital SLR cameras and camcorder with a 3.5 mm (diameter) stereo mini-pin jack, and fits into compatible camera shoes, and connects to the camera via the 3.5mm mini-plug.
For many vacuum tube microphone, it takes some time to warm up before reaching the optimum working condition. Microphone manufacturers often advise you to warm up the microphones in 2 to 3 minutes, up to 15 minutes. So once you turn on the microphone, keep it in working condition until the end of the recording.
The proper use of XLR plug, and sometimes temporarily add or replace the microphone, pick up the XLR head plunge and plug, easy to put three feet twisted or broken.
Stereo microphone system
Shotgun microphone system
BOYA wireless microphone
BY-LM300 Dual-Lavalier Microphone
Conference microphone system
BY-MC2 Conference Microphone
BY-WM4 Wireless Microphone